One ceiling light no power, all others work

[speedway]

Newbie RV owner (04 MADP 4017). I am converting 18 “ tube ceiling lights to LED. The forward most light has no power, light wasn’t working, assumed it was bad ballast but not the case. I can get light to work using jumper wire from the light next to it. Could this forward light be on a different switch? Still getting acquainted with this rig. All help/suggestions appreciated!

[Lug_Nut]

Originally Posted by speedway

Newbie RV owner (04 MADP 4017). I am converting 18 “ tube ceiling lights to LED. The forward most light has no power, light wasn’t working, assumed it was bad ballast but not the case. I can get light to work using jumper wire from the light next to it. Could this forward light be on a different switch? Still getting acquainted with this rig. All help/suggestions appreciated!

Yes, it is possible that a separate switch may be involved. If not, you should be able to feed a line through the ceiling. Best of luck.

[Ljwt330]

On my coach, the forwardmost light is on a separate switch, located by the entry steps and labeled "entry." I had the same issue as you--no power to that fixture--until I discovered the switch, low by the floor but at eye level when outside looking into the stair well.

[GaryKD]

Hi speedway,
Ljwt330 has the answer. Check the passenger right hand console of switches. It will be one of these switches. Also make sure the switch at the fixture is turned on.

[Dizzee2020]

Yes. One switch for the front fixture and another switch for the 2 fixtures in the kitchen/dinette area.

[speedway]

Originally Posted by Dizzee2020

Yes. One switch for the front fixture and another switch for the 2 fixtures in the kitchen/dinette area.

Switch found, light works. Thanks to all for the help!