When plugged into shore power one of the pages shows voltage on each of the legs and amps being drawing individually and combined. One of my legs never reads or shows anything even thought the voltage is correct. AC etc. units still run fine. The amp draw is shown correctly. How does one correct this sensor or reading? Thanks
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
When plugged into shore power one of the pages shows voltage on each of the legs and amps being drawing individually and combined. One of my legs never reads or shows anything even thought the voltage is correct. AC etc. units still run fine. The amp draw is shown correctly. How does one correct this sensor or reading? Thanks
Check your circuit breakers, some people turn off unused circuit breakers which could be a leg feed to the PCS causing 1 leg not to read.
Talking to a technician today he says there is just a sensor wire twisted around the Leg/feeder that is most likely loose seeing as it works sometime. Anyone familiar with this?
Linear Mode
