Sanicon Hose and Sleeve Installation
Well I finally got around to posting my Sanicon Turbo 600S in the 05 DS. I wanted to post the pictures with notes above them but could not figure out how to do it so hopefully the pictures below make sense with the comments above.
I studied all the installs I could on the internet to help with my layout. Lots of great ideas on the forum and I did duplicate parts of many of them in the wet bay
The first challenge and the main reason for the post was how to get the sleeve over the hose to protect it. I went with the Protec Nylon Sleeve option many have recommended on iRV2. I searched how others installed it on the hose but no luck. Studied the possibilities and landed on a method that was super simple and easy to do. Maybe a 5 minute job to get the sleeving on the hose if you have similar items to do it with. I used a 1.5” pipe, push broom handle and a nut and bolt.
Picture 1 is the hose and Protec sleeve
Picture 2 is the 1.5” section of pipe, broom handle and nut and bolt. I used a blind nut as it was just easier to push in the broom handle and not worry with getting to it in the pipe.
Picture 3 is the broom handle to pipe:
Picture 4 is attached pipe with broom handle to hose and add a few tie wraps to secure it. Not sure they were needed as it was a tight fit with the pipe and broom:
2005 Newmar Dutch Star 4010, Cummins 370HP
2014 Ford Edge Limited