Community Forums

montiem · 06-04-2012, 08:20 PM

My monitor for my cameras come loose, I removed it and when I did the screws that held it in was stripped, may have been when installed at factory or worked on before I bought the coach. The monitor started to lose the signal on the side cameras but started working again when coach was started the next time but the right or the left camera would lose the signal again, also the the Computer does not display at any time. Has anyone had experience with the monitors, I was thinking that replacing the monitor may solve the problem. Any suggestions!!!!!

"007" · 06-04-2012, 10:59 PM

The monitor shows mounted in dash panel, can you check the wiring pins in plugs for loose wiring in plugs.
Your explination would tell me a loose wire or plugs will seat right in back of monitor.

Lug_Nut · 06-05-2012, 09:12 PM

I have experienced intermittant operation in the past. Each time I removed the dash and reconnected the main coax cable and it work great for a while. I've done that at least twice now and it looks like itn is in need of it again. This time I will clean it and spray it with connector formulated stuff.
Yours is more than likely a loose or oxidized connection.

Peter

montiem · 06-08-2012, 07:41 AM

I did take the dash off and found the connections, I unplugged the connections on the rear of monitor and reconnected them. I traced the wires to the Trip Tek and unplugged the data connection and replugged, it worked. This morning I went to coach and started the the engine, turned on the monitor and the Trip Tek did not work, I guess it needs cleaning, going to try that today and see, if not I think I will just do without the computer, to much trouble. In my coach I have to take the dash off, take the drawers out then the surround around the drawers, what a mess,

montiem · 06-12-2012, 02:41 PM

I thought I had my monitor fixed, the "no Signal" problem, It worked for about 100 miles but I think I found the problem. I had it set on day/night, I noticed it was set on day I then swapped it to auto, within a few miles it messed up. Turned it back to day and it started working again, not immediately but after 15 minutes or so. I am going to leave the auto off and see if it works. I Unfortunately my Trip Teck still does not work