I'm sure various Rv manufacturers use different methods of securing TV's. I have pulled two TVs by first removing the facia board. Look behind the facia board, it is probably held on with metal brackets. Both the TVs I pulled were resting on a flat piece of plywood that laid on top of the floor of the area where the TV was installed. This plywood was held in place by only two screws in the front. Remove the two screws and the flat piece of plywood can be slid out of the cabinet with the TV still attached with the nylon mounting strap. You may have to remove two plastic mounting brackets at the top sides of the TV before sliding the plywood and TV out. Once lifted out you wil have a TV mounted on a piece of plywood, only secured with a nylon strap. Again, this is what I observed on two Fleetwood products. To reinstall the TV,plug it in, attach a cable connector and then it is just slid back in with the nylon strap in place. You screw in the piece of plywood, reinstall the top/side plastic brackets and then refasten the facia.
|