Community Forums

djdobbins1 · 06-06-2017, 11:55 AM

My Cablemaster won't work and has lost 12vdc source to the relay. Where is the fuse or circuit breaker located for the power to the Cablemaster?

Alpine 40' MDTS

Old Scout · 06-06-2017, 12:48 PM

12v fuse panel in bath / bedroom, usually in cabinet below sink basin.....

Janet and Todd · 06-06-2017, 04:17 PM

Or in the tank bay. Or (like my case) in the Hydro Hot bay behind the secret door of the utility (wet) bay.

Jeeper64060 · 06-13-2017, 09:31 AM

Mine is in the panel below the sink. I had a wiring issue - the fuse that was supposed to be for the cable master was wired to something else. After tracing it out I swapped wires so the fuse map is now accurate. It had a 5 amp fuse in it - went to 20A.

Terry W · 06-13-2017, 10:00 AM

Quote:

Originally Posted by Jeeper64060

Mine is in the panel below the sink. I had a wiring issue - the fuse that was supposed to be for the cable master was wired to something else. After tracing it out I swapped wires so the fuse map is now accurate. It had a 5 amp fuse in it - went to 20A.

I had the same issue, it's been a few months but I believe there are two purple wires and they were swapped at the fuse block. I checked the fuse that was labeled for the Cablemaster and it was good which lead me down the wrong path,

Once I checked all the fuses I found one blown, turned out to be the one I was looking for so I swapped the wire to match the label, replaced the fuse and all is well. IIRC, it was under fused so as to be correct for the way it was originally labeled.

Terry