Any tips on removing hardwood floor?

[miatawnt2b]

I want to refurbish the flooring in my 2000 SeaBreeze. I have removed the carpet, but there is hardwood through the kitchen, toilet area, and hallway. The hardwood appears to be glued down to vinyl in these areas and I am wondering if anyone has tips in lifting this up.

-J

[C1v1leng]

I used a small air chisel with a wide angled bit. Took it up but it wasn’t easy. Had to fill some divots where I went too deep. Came out fine though

[gmc70]

Air Chisel will work if you have a big enough compressor. They use lots of air and I mean lots. You can use a multi tool little slower but less damage to subfloor. glued down flooring is a PITA. If you have the time and patience it can be done. I have done a couple of houses and two of our MH's . Good luck to you and your knees.

[miatawnt2b]

Played with it a little tonight. The floor isn't coming up from the vinyl. however, the vinyl is coming up fairly easily. I will need to multitool around the cabinets to cut through the vinyl as it runs under the cabinets, shower, etc. So this won't be super hard.

Thanks all.
-J

[C1v1leng]

Mine came out from underneath the cabinets without issue. It doesn’t extend very far below them. Not as much glue there either