Lounge Slide Problem

[morris44]

We have a 2004 National Dolphin, 35 ft, 2 slide. The lounge slide has started to stick (metal to metal contact) at the top forward corner of the opening. Has anyone every had this problem? Any and all suggestions are welcome.........

Thanks in advance.

[skyexplorer]

Maybe the bearing in front slide rail is wearing out casing rail to sag slightly . That bearing is in the wheel well and exposed to lot of gunk. You can adjust the front corner of the slide to raise the slide with a jack and some blocks. There is a bolt on the very end of the rail. Jack up the room on that corner check your bearing play. If good loosen bolt and raise corner just a little. Little goes long way on top.