Hi, I dont have any 120 v power in Passenger rear slide. All GFI I found were OK.. Also the Girard awning on the same side is not extending ( maybe related? )
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
You check the gfi in your wet bay? All the way on the right top right. you should also have a gfi in the second or third basement door on passenger side and one underneath front slide on passenger side.
In the bay under the slide there is a 120V outlet, or maybe a 120V inline connector now. There should be a 120V plug that fits into that outlet. The plug connects the power to the slide. Note that there is a lot of slack in the plug cord so that cord can move with the slide without pulling out of the outlet. Alternatively it might be an in-line connector now (can’t recall). Same concept as the plug and outlet . If the plug comes out of the outlet, or if the inline connector comes apart the power to the slide will be cut off. Then again, this may have nothing to do with your issue.
__________________
2021 Allegro Bus 37AP
2019 Wrangler Rubicon Unlimited
You check the gfi in your wet bay? All the way on the right top right. you should also have a gfi in the second or third basement door on passenger side and one underneath front slide on passenger side.
In the bay under the slide there is a 120V outlet, or maybe a 120V inline connector now. There should be a 120V plug that fits into that outlet. The plug connects the power to the slide. Note that there is a lot of slack in the plug cord so that cord can move with the slide without pulling out of the outlet. Alternatively it might be an in-line connector now (can’t recall). Same concept as the plug and outlet . If the plug comes out of the outlet, or if the inline connector comes apart the power to the slide will be cut off. Then again, this may have nothing to do with your issue.
I will look at this route... Will ley you know. Thanks
Look under the slide for connectors that look similar to the below photo. These are Molex connectors used to connect the slide wiring to the coach wiring. Sometimes they can pull or vibrate loose. In addition to the GFCIs mentioned, there is another one in the half bath on the face of the cabinet just below the countertop.
__________________ 2017 Phaeton 40IH XSH Maroon Coral - Power Glide Chassis with IFS
Previous '15 Tiffin Allegro RED 38QRA and '06 Itasca Sunrise 35A
'16 Jeep JKU Wrangler Sahara or '08 Honda Goldwing
Thanks everyone for the help.
Found the problem, there is a 110v outlet in the bay under the first passenger slide. That outlet is part of the Vanity / Bedroom TV slide breaker. The connexion inside that outlet was bad, I replaced the hole outlet with a home style one , much better....
Look under the slide for connectors that look similar to the below photo. These are Molex connectors used to connect the slide wiring to the coach wiring. Sometimes they can pull or vibrate loose. In addition to the GFCIs mentioned, there is another one in the half bath on the face of the cabinet just below the countertop.
2017 Phaeton 40IH XSH Maroon Coral - Power Glide Chassis with IFS
Linear Mode
