Community Forums

RVdus · 01-09-2016, 01:36 PM

I have a 2014 36LA and the rear slide has started acting up - jockeys side to side and gets stuck. After running it back and forth it still goes in/out but starting to be a concern. Anyone else have this issue and advice on how to remedy it?

luvlabs · 01-10-2016, 08:41 AM

Sounds like your slide motors are out of sync. Go to the Lippert Components website and read up on Schwintec slides. There will be a section on troubleshooting and how to resync the motors. Also search on this forum for information.

RVdus · 01-10-2016, 11:34 AM

Thanks for the tip! I was able to find a video on the Lippert site showing how to re-sync the slides and will give that a try. I'd post the link but their site doesn't seem to be cooperating - here's a link to the support page anyway for anyone else interested:

Technical Support Center and Videos

deasnealy · 01-11-2016, 02:50 AM

I have had the same issue for years. NEVER could get the problem corrected by Tiffin. . Two motors and two new controllers. Still does not smoothly extend.

tholtman · 01-11-2016, 08:19 AM

My rear slide just started acting up too. I would extend very slowly and inconsistently but would retract normally. Dealer is ordering a new schwintek control box under warranty.