2018 Phaeton. Had the windshield replaced , driving home noticed the left camera only displayed a blue screen..... found the yellow wire going to the mirror broke, repaired same - still no camera
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
2018 Phaeton. Had the windshield replaced , driving home noticed the left camera only displayed a blue screen..... found the yellow wire going to the mirror broke, repaired same - still no camera
Blue screen usually means there's no source. So either the camera is bad or the wires going from camera to display are bad
The techs probably disconnected the cable inside the genset compartment. ItS usually tucked up in the upper corners. Unless they removed the mirror, then there’s another connection in the arm accessed by removing the head.
I have the same problem in my 2020 Tiffin 34PA. How did you access the wiring harness in the mirror arm? I have tried all the connections inside the dashboard, but it's not obvious to me how to access mirror arm. I would appreciate any insights you may have.
There are connectors in the arm. The left turn marker light on the arm pops off and allows access to these connectors. I had to end up pulling slack from inside the coach to this access. Go to Velvac’s site and there Are downloadable tech sheets with detail.
Linear Mode
