Community Forums

tiffin31 · 11-20-2022, 02:53 PM

2017 Tiffin 31 MA open road- electrical plugs in front cab passenger side and 3 plugs under bathroom sink cabinet- all quit working this afternoon. We have re-set GFI's and visibly looked at fuses unknowing which one is the one. Any one with knowledge will be greatly appreciated.

Warhorse6 · 11-20-2022, 04:01 PM

You might have a gfi outlet in Your wet bay. Check that. Mine is up on the top right of the wet bay. That gave me fits and had the same issue you described

**Lt Dan** · 11-20-2022, 04:05 PM

Did you find the GFCI on the front of the bathroom sink cabinet? Sometimes it's easy to overlook where it's located. Also, you should have a GFCI in the basement area near the front and maybe another one in your wet bay.

High Road Travelers · 11-20-2022, 10:09 PM

Could it possibly be a tripped breaker?

Kjon · 11-21-2022, 01:56 PM

A tripped GFI or breaker seems likely. GFI's are often chained in that they control multiple outlets.

SamKVA · 11-21-2022, 08:08 PM

Not sure where your outdoor outlet is located but check that GFCI as well.

Sam

dssl · 11-21-2022, 08:22 PM

That outlet by the Passenger seat may go through the inverter. What inverter do you have? Is any other inverter circuits working? Entertainment, residential refrigerator? if you have one.

High Road Travelers · 11-29-2022, 03:36 PM

To the OP: Did you find the issue, and if so, how was it resolved? This info could help someone else at some point.
Thanks,

smithib · 11-29-2022, 07:34 PM

I recently had the same problem on my 2016 Phaeton 40QBH. After looking for the GFI outlet I realized I had no power on any of the 110 outlets while driving down the road. The problem was that the inverter had been turned off. Of course the easy fix was to just turn it back on.

tiffin31 · 11-29-2022, 09:37 PM

Quote:

Originally Posted by wog099

To the OP: Did you find the issue, and if so, how was it resolved? This info could help someone else at some point.
Thanks,

It ended up being the magnum in outside electrical bay that needed to be re-set. I thought I had posted that we fixed issue with re-set. No problems since.