|
01-19-2021, 02:36 PM
|
#1
|
Senior Member
Join Date: Nov 2013
Posts: 5,782
|
Power Control System Central Monitor Panel Issues
My Power Control System Central Monitor Panel is showing a power draw of 18 amps for the rear A/C. A/C is not running and I tried flipping off the breaker but it reads the same even with the breaker off.
I shut power pedestal on and off, no change. I ran the rear A/C, no change running or off. I ran the front A/C, no amperage indicated while running.
Is there a reset for this system? I don’t remember seeing that value before for the rear A/C.
__________________
2015 Tiffin Phaeton 40QBH
2018 Chevrolet Colorado Toad
Roadmaster Tow Setup
|
|
|
|
Join the #1 RV Forum Today - It's Totally Free!
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
|
01-19-2021, 02:45 PM
|
#2
|
Senior Member
Join Date: Jul 2014
Posts: 35,446
|
Your system ID's what's running, OR amp draw on each leg.
Never seen one that monitors each device
If on 30 amp power, there is only one leg to monitor.
Do you have any other breakers off in the main panel ?
They use random breakers to supply power to the system. If one is off it gets wonkie.
|
|
|
01-19-2021, 05:00 PM
|
#3
|
Senior Member
Join Date: Nov 2013
Posts: 5,782
|
All breakers are on. Just concerned it might start shedding loads unnecessarily if it thinks the rear A/C is drawing 18 amps.
__________________
2015 Tiffin Phaeton 40QBH
2018 Chevrolet Colorado Toad
Roadmaster Tow Setup
|
|
|
01-19-2021, 08:25 PM
|
#4
|
Community Administrator
Tiffin Owners Club
Join Date: Sep 2013
Location: DFW, Texas
Posts: 21,570
|
Is your block heater turned on? It could be on the same circuit.
__________________
2017 Phaeton 40IH XSH Maroon Coral - Power Glide Chassis with IFS
Previous '15 Tiffin Allegro RED 38QRA and '06 Itasca Sunrise 35A
'16 Jeep JKU Wrangler Sahara or '08 Honda Goldwing
|
|
|
01-20-2021, 05:56 AM
|
#5
|
Senior Member
Join Date: Nov 2013
Posts: 5,782
|
Quote:
Originally Posted by Lt Dan
Is your block heater turned on? It could be on the same circuit.
|
No, not on. Think I may call the company today. This may be just operator misunderstanding, the coach is new to us and much diff than our prior Newmar gasser.
__________________
2015 Tiffin Phaeton 40QBH
2018 Chevrolet Colorado Toad
Roadmaster Tow Setup
|
|
|
01-25-2021, 07:49 AM
|
#6
|
Senior Member
Tiffin Owners Club
Join Date: Feb 2014
Location: Elverta, CA
Posts: 196
|
PCS has a memory
On my PCS it stores and remembers the last amp draw when the device was running. I think it uses this to determine when to "unshed" a load after it has been shed. The back A/C is usually at the top of the list for which device to shed first. My PCS shows what this amp draw WAS, not what it is drawing NOW. So, it doesn't change much. I will try to get a pic next time I'm at the RV.
__________________
Brad & Dianna
2017 Allegro Bus 37AP
2015 Jeep Cherokee
|
|
|
01-26-2021, 05:20 AM
|
#7
|
Senior Member
Join Date: Nov 2013
Posts: 5,782
|
Quote:
Originally Posted by BradS
On my PCS it stores and remembers the last amp draw when the device was running. I think it uses this to determine when to "unshed" a load after it has been shed. The back A/C is usually at the top of the list for which device to shed first. My PCS shows what this amp draw WAS, not what it is drawing NOW. So, it doesn't change much. I will try to get a pic next time I'm at the RV.
|
Thanks for the information. I did read about the storage of the last value, however the rest of my stored values are zero so not sure how to interpret them.
__________________
2015 Tiffin Phaeton 40QBH
2018 Chevrolet Colorado Toad
Roadmaster Tow Setup
|
|
|
01-29-2021, 11:04 AM
|
#8
|
Senior Member
Tiffin Owners Club
Join Date: Feb 2014
Location: Elverta, CA
Posts: 196
|
Shed process
I'm sorry I really can't remember exactly how this works. I think the AMPs last used are stored/updated during the shed process. So, for those loads that have never been shed, they will say 0 AMPs. Hope this helps.
__________________
Brad & Dianna
2017 Allegro Bus 37AP
2015 Jeep Cherokee
|
|
|
01-30-2021, 05:11 AM
|
#9
|
Senior Member
Join Date: Nov 2013
Posts: 5,782
|
Quote:
Originally Posted by BradS
I'm sorry I really can't remember exactly how this works. I think the AMPs last used are stored/updated during the shed process. So, for those loads that have never been shed, they will say 0 AMPs. Hope this helps.
|
Thanks, that may just be the piece of information I needed and would make sense. I have had several other issues recently so the Power Panel kind of went to the back burner. Tough when you get a new to you coach, you slowly find all the little issues the prior owner never fixed [emoji1]
__________________
2015 Tiffin Phaeton 40QBH
2018 Chevrolet Colorado Toad
Roadmaster Tow Setup
|
|
|
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Discussions |
|
|
|
|
|
|
|
|
|
|
|
|
|