When pressing the OUT button on my Living Room Power Gear slide, I sometimes have to depress multiple times to activate. IN button never has an issue.
Is this typically a switch issue (pictured) or are there relays in the system?
If a switch, where can I purchase a direct replacement? If relays, anyone with similar coach advise where most likely installed?
Thanks, Tim
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
I too had an issue with the slide out button on our Tiffin. I tested the switch by swapping it out with another switch close by and found it to be bad. I found a nearly identical switch at a local RV parts store and made the swap. Easy swap out, but I lots spent more time in the car on this problem than I did in the RV.
__________________
May your smiles be many and the miles be plenty.
Karen & Allen Van Zandt
2014 Tiffin 34 QFA, 2013 Honda CRV3
I have been having a similar issue with the Schwintech slide on my 2022 32SA. This is a spyder system. Tiffin techs told me most of the time this a sync issue and to resync the motors. I have not tried this yet.
That's going to be either a SPDT or DPDT momentary with center off. You should be able to measure the dimensions of the switch and get one on Amazon or contact Tiffin parts.
__________________ 2017 Phaeton 40IH XSH Maroon Coral - Power Glide Chassis with IFS
Previous '15 Tiffin Allegro RED 38QRA and '06 Itasca Sunrise 35A
White '24 Jeep JLU Wrangler Willys
Posting result in case anyone else has the same switch situation.
Found the replacement on amazon using the info from Lt. Dan.
Literally snapped right into the original faceplate.
Slide out worked fine with new switch maybe 5 times, thought problem solved and then hesitated during last trip.
Connections seem secure at motor so ordered new control board with relays. Old board has soldered relays. Will see how this goes, was at least easy to locate board.
2017 Phaeton 40IH XSH Maroon Coral - Power Glide Chassis with IFS
Linear Mode
