Triplevision camera'13 Phaeton

[joew01]

I have a 2013 Tiffin Phaeton with a triplevison camera system. Not sure what I did to it, but when I put the right or left blinkers on the system goes into a split screen mode. Anyone know how to set it back to the proper mode when the blinkers are on? The main function menu has a reset, but that did not fix it. Wondering if there is a way to reset it to the factory delivery mode.

[simonsrf]

Originally Posted by joew01

I have a 2013 Tiffin Phaeton with a triplevison camera system. Not sure what I did to it, but when I put the right or left blinkers on the system goes into a split screen mode. Anyone know how to set it back to the proper mode when the blinkers are on? The main function menu has a reset, but that did not fix it. Wondering if there is a way to reset it to the factory delivery mode.

Mine isn't a split screen when I put the blinker on, it is either left camera or right camera, then when blinker is off, it is the back camera. Is that what you are saying?

Also, you can change the camera by pushing the "M". MIne is set to cam1 (left), cam2 (center), cam3 (right). There are lots of options behind the M button.

[CoastieSCPO]

Turn your monitor off. Put the ignition in the on position without starting it like you may do when retracting or putting out the slides. Press the on/off button on the Triple Vision monitor for 10 seconds and a "factory reset" notation will be displayed. Turn the ignition off then start the engine and turn on the monitor. Hopefully, everything should go back to normal.

[Bruce W]

It may be a minor thing to most people but when I leave the display on split screen, my 2013 Phaeton shows the left camera on the right side of the screen and the right camera on the left. I personally want to see the Driver's side on the left split screen. If I see motion on the monitor and glance to the display now I get confused, especially when I have traffic on both sides.
The only way I see to set this is to get under the dash, swap the cam2/3 cables and swap the 2 trigger wires from the turn signals.

Does anyone know of a way in the software setup of swapping the split screen displays?

Also has anyone installed a forward camera on top of the motorhome (or elsewhere) as a Cam 4 input?

[djbmsu]

There is also a button for changing that back also

[Bruce W]

Originally Posted by djbmsu

There is also a button for changing that back also

Could you elaborate ? Are you referring to my left right issue? I've looked thru the pamphlet size manual without much success.