Community Forums

Razorrick · 06-14-2020, 08:24 PM

Friends just purchased and only the living area tv receives a signal. Others just static. Any help would be appreciated. Thanks

Dale & Mark Bruss · 06-15-2020, 02:21 AM

Unless it has been rewired, the antenna coax is split to all the TVs. The external Park TV coax feed comes to the TV antenna switch and toggles with the roof antenna with the LED indicating the amplifier for the roof antenna is on.

ave you checked that each TV is set for antenna source? In our Bounder we used satellite and HDMI for all the TVs and none were set for antenna source.

Razorrick · 06-15-2020, 05:54 AM

Where does this antenna spit and the led indicator located? Thanks

Dale & Mark Bruss · 06-15-2020, 06:40 AM

On our 2016, the splitter was located behind the set of drawers under the closet to the right of the bedroom window. Take out the drawers and back against the outside wall.

TimmyB · 06-15-2020, 07:41 PM

Quote:

Originally Posted by Razorrick

Where does this antenna spit and the led indicator located? Thanks

If your is like ours, this is what Dale and Mark are talking about. It comes in as one line, leaves as four more (with room for an additional four). Take out the top two (or all four) of your drawers for easy access.

Phochief · 06-16-2020, 12:12 AM

Quote:

Originally Posted by Razorrick

Friends just purchased and only the living area tv receives a signal. Others just static. Any help would be appreciated. Thanks

It could also be the HDMI Switch and Splitter, located behind the TV in the bedroom. Make sure it's plugged in and lights up. Make sure all of the TV's HDMI cables are connected to it. Each HDMI cable connected to the splitter goes to one of the TVs in the Bounder 33C. Mine has four HDMI output cables from the splitter (bedroom tv, middle tv, front tv and outside tv).

Also, make sure each of the other TVs is set with the correct "source" input (hdmi 1, hdmi 2, hdmi 3).