Community Forums

tkatt · 09-22-2013, 08:49 AM

Hi
I'm hoping someone here can help as phoning the dealership is of no help and the manuals I've read

The tank level monitor just stopped working but the battery monitor which is on the same panel is working ??
Where is the fuse panel for this? I have found 3 ...one is in the dash panel ,next one in back bedroom by the power panel and the last one outside in the same compartment as the inverter is ...all fuses I've checked are fine ...if I could find the actual fuse then maybe I could for sure rule out a fuse and look for something else ..
Thanks
T

R2Home · 09-22-2013, 09:07 AM

Have you looked at the wiring in the water bay? We had a similar issue and it turned out that one of the very small wires had worn through. Spliced the wire back and all was OK.

**CLIFFTALL** · 09-22-2013, 09:16 AM

Welcome to irv2. The fuse for the tank monitor is tied into one of the two propane detector fuses in the BCC ( battery control center. ) where your inverter is. However since the battery monitor still works , it may not be that fuse. Your dealer may be if no use but FW will assist. 800-322-8216. Good luck and please update us when you can.