Bedroom slide will not deploy

[Hogbus]

2010 40x bedroom slide will not deploy. Picked up from storage this morning. Parked, leveled, deployed front slides.
Nothing happens when I press switch. No noise no movement nothing.
Fuse? Where would I look. Under bed or somewhere else? Everything else is working. Front slides OK. Have wiring diagram but can't understand it.
Thanks, JD

[Hogbus]

I see a 20 amp fuse in the diagram for rear slide. It is in the rear fuse box. i don't know where to locate the rear fuse box. I have a BCC would it be in there?
Thanks, JD

[gripper]

I have an '05 Fleetwood, that had the same issue. I had to call a mobile RV service guy, who showed me a blown 20 amp fuse, which was located in the left rear storage/electrical compartment, with the power cord other electrical boxes. In fact, the fuses for all three of my slides are there. Cost me $80 for him to come out and replace the fuse. However, he did give me a spare 20 amp fuse.

[Hogbus]

found the fuse box in bathroom. All fuses good. Pulled panel to look for loose connections all good. Pulled switch panel to look at connections. All good. Before taking bed apart to check motor gave her another try and she worked!
JD

[Clayobx]

Whew! Hope the gremlins stay gone. Had one show it's nasty face today. New macerator pump on the way from Amazon. Going to be a ummmm phew! Job. Ugh!

[flaggship1]

Originally Posted by Clayobx

Whew! Hope the gremlins stay gone. Had one show it's nasty face today. New macerator pump on the way from Amazon. Going to be a ummmm phew! Job. Ugh!

Clay, I have a Tecma and when (not if) it cr**$ out I'm pretty sure I'm paying someone to handle it. Or maybe give you a call...

Edit... Think I will handle slides the same way... double