Discovery: Fleetwood Discovery LXE camera selector switch

[slate]

I posted on a previous thread with no answer. Was an old thread though. We just purchased a used 2021 44H disc lxe with these switches in a couple spots in the coach. A previous thread stated to turn the power on for the cams in the dash monitor. Then put your tv(s) on input AV1 and the switches will then work. I could not get mine to work doing this.

[alank]

Turning on the dash camera is the first step, then turn on the main TV, check all the inputs on the TV to find the dash cameras. It could be that it didn't get plugged in to the dash monitor, or the TV, or if the TV is on a lift, the wire may have pulled out of the TV. My wires were positioned so they were being slightly pulled on when the lift was operated.
Once you get the camera picture on the TV, then you can use the switch to cycle through the different cameras.

[slate]

Yes I turned the 2 TVs on that are supposed to have this feature. The lift on the main tv may have caused a wire to come off, but the other tv is fixed so I doubt both would have this issue. I cycled through the inputs with no luck. You’re probably right about the connection to the dash monitor. That might be the problem. Any other ideas?

[slate]

Monitor unplugged from new. This feature would have never worked. So much for PDI!