I have a 2008 Fleetwood Excursion 40e and I am trying to replace the rear Driver's Red tail light. I ordered a new one from REV RV it has two bolt threads sticking out the back. Anyone ever changed this out. I know I can remove the two little screws holding the lens cap and replace the bulb but I want to replace the whole unit. How do I get behind the bezel. I don't see away from the inside. My new piece has two threads screws out the back and a red, black and white wires that are crimped. looks like all I do with the wires is plug them in being crimped and all. But I need to get behind the bezel and loosen two nuts disconnect the wires to pull the old one out. Any help would be greatly appreciated the RV repair place wants 3 hundred to do this. Not by the hairs of my chinny chin chin. I was told that I need to pull on one side of the bezel but I don't want to brake something. So I am reaching out. Thanks
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
Does the panel around the lights have some play in them? Possibly yours is the same as my 2017 FW. You pull out on the lower end of the panel, then slip the panel tabs out of the slots in the rear cap, then the lights are accessed from there. There are clips that are glued to the panel backside that are known to come loose and possibly result in loosing the panel.
Fleetwood Excursion Tail Lights Replacement
Linear Mode
