Bounder: Leveler will not Turn On 2017 Bounder 35K

[CLR]

I just pulled into a campground and my leveler will not turn on, Yes I have played with the parking brake but that did nothing. Wires are plugged into the back of it.
Where is the Fuse or Breaker for them on a 2017 Bounder 35K?
Thanks in advance,

[deblas]

Whenever I have issues with the leveling system, I’ve had success with simply unplugging the harness from the controller, wait a few seconds and reconnect.

Have you tried that?

[craigd853]

Originally Posted by CLR

I just pulled into a campground and my leveler will not turn on, Yes I have played with the parking brake but that did nothing. Wires are plugged into the back of it.
Where is the Fuse or Breaker for them on a 2017 Bounder 35K?
Thanks in advance,

Hello, check the ground coming off of your pump that is attached to your chassis. I lost all power to both my contol panel and the pump, after trouble shooting I found the ground wire that attached to the chassis from the pump was loose because the bolt was stripped out. Also there might be an inline fuse close to where the pump is. Good Luck

[CLR]

Originally Posted by CLR

I just pulled into a campground and my leveler will not turn on, Yes I have played with the parking brake but that did nothing. Wires are plugged into the back of it.
Where is the Fuse or Breaker for them on a 2017 Bounder 35K?
Thanks in advance,

Thanks, I had to turn the ignition on and off a couple of times for it to sense it. Crazy
It is now working again as prescribed.

[computerguy]

Recently I had an intermittent issue on my '16 Bounder. Turned out it was a corroded wire connection. So in your situation it may just be a coincidence it started working, or, most probably a corroded wire/ground. Fleetwood, in it's ultimate wisdom, put all these connections in the weather in the front of the motorhome. I didn't see a problem until I took it apart. But I did fix it and not a hint of a problem since I fixed it.
In my opinion, it is best to troubleshoot this when you have time. Check that ground someone else explained. Check your chassis battery connections (That was my issue. There are like 5 wires coming off the chassis battery and one of those is for the BCC which powers your levelers).
Next time it happens it might be completely inconvenient and might not magically start working again.