|
07-01-2021, 05:24 PM
|
#1
|
Senior Member
Join Date: Oct 2018
Location: Washington
Posts: 307
|
Overheating
It was very, very hot last weekend (116F), and while pulling a boat and near capacity in the rig itself, my rig performed admirably until I started pulling a grade. The temp gauge would climb until I stopped for a bit. It didn't seem to matter if I was driving slow or fast. It didn't happen on the way to site on Thursday (much cooler day).
I recently replaced the surge tank, everything went well - is there an issue with these units trapping air somewhere?
Are there issues with temp regulators? (Thermostats)
I have heard that my 330Cat has 2 regulators, what's the second one for?
I plan to clean the inside of the radiator this weekend, but I'm not sure what else to look at.
Thoughts?
Thanks in advance!
__________________
2003 Fleetwood Discovery 39L
|
|
|
|
Join the #1 RV Forum Today - It's Totally Free!
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
|
07-01-2021, 05:46 PM
|
#2
|
Senior Member
Join Date: Apr 2011
Location: Powell River, B.C.
Posts: 31,311
|
Caterpillar used two different water pumps on the 3126B/E engines , if your rig has the water pump driven by a small V belt you need to make sure the belt is tight .
Two " Regulators " not sure exactly why , but think that a single regulator the opening was too small to provide coolant flow for times when max flow to the rad was required .
You didn't mention side or rear rad configuration , and if you were manually selecting a lower gear to keep the RPM up around 2,000 on your climb.
BTW; Cummins says to clean the rad in a rear rad chassis , annually or every 7,500 miles , I think that's a good idea for any rear rad coach.
__________________
99DSDP 3884, Freightliner, XC, CAT 3126B, 300 HP /ALLISON 3060
2000 Caravan toad, Remco & Blue Ox.
|
|
|
07-01-2021, 06:38 PM
|
#3
|
Member
Monaco Owners Club Holiday Rambler Owners Club
Join Date: Oct 2014
Location: Alcoa Tn
Posts: 92
|
I had an 04 Winnebago Journey with a cat that I was having overheating issues.
The slobber tube from the engine was misting oil that was stopping the stacked CAC and Rad up. You need to check both the front and in between them. I cut an opening in the top of the shroud for access. ( I found this tip on Google. ). Also extend the slobber tube to the rear of the coach. I have a few pictures of the shroud it interested PM me and it will send
Good luck with it
__________________
John & Glenda
07 Endeavor 40SFT
Toad 09 Silverado
|
|
|
07-02-2021, 11:02 AM
|
#4
|
Senior Member
Join Date: Oct 2018
Location: Washington
Posts: 307
|
My crankcase vent is extended past the radiator, so that's no issue.
It's a rear radiator.
I let the transmission choose gears for most of the trip, up until the last two grades, I downshifted early on them and kept the RPM around 2000-2200, that seemed to help, but still had the issue.
Pulling the rig out to clean the radiator Saturday Morning.
__________________
2003 Fleetwood Discovery 39L
|
|
|
07-02-2021, 11:12 AM
|
#5
|
Senior Member
Join Date: Oct 2014
Posts: 7,868
|
Yes, the front of the CAC need to be cleaned annually. More often if in areas with a lot of dirt, leaves, etc that can block air flow.
Manually choose a gear where you are 2,000- 2,200 RPM AND (an important AND) just under WOT.
Said another way, you want to be able to floor it and have just a little bit of acceleration left.
__________________
Brett Wolfe
Ex: 2003 Alpine 38FDDS. Ex: 1997 Safari Sahara. Ex: 1993 Foretravel U240
|
|
|
07-23-2021, 06:49 PM
|
#6
|
Member
Join Date: Aug 2019
Location: Georgia
Posts: 67
|
Mine would overheat for no reason at all. At first it was seemingly on steep grades or in hot weather, then it became completely sporadic. Mine was a failing fan clutch and found out it was fairly common. I have a 2008 rig, Fleetwood Discovery. The part itself isn’t that big a deal but getting to it to replace it is a huge deal. When you crank your rig up, tie a few ribbons to the back grate and ensure they’re blowing horizontally. If not, it’s your clutch or a slipping belt.
|
|
|
07-23-2021, 06:59 PM
|
#7
|
Senior Member
American Coach Owners Club
Join Date: Jan 2011
Posts: 2,742
|
You need to Lean to Drive your Rig on Grades- Down Shift and keep the RPM's way up-- Don't be in a Hurry- Continue to downshift as necessary to keep the RPM's around 2300 - There's a Governor on your Engine so don't worry.
__________________
Chuck
Brownsburg Indiana
1992 American Eagle-8.3C-450hp
|
|
|
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
|
|
Thread Tools |
Search this Thread |
|
|
Display Modes |
Linear Mode
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Discussions |
|
|
|
|
|
|
|
|
|
|
|
|
|