Transformer Question

[jblack2743]

Have 2016 fleetwood storm 30 l recently remover drawer under stove. Found 110 outlet with a low voltage transformer plugged in wires disappear into loom any ideas what this transformer powers ?

[randyrv]

Just a guess but maybe 12 volt cigar outlet?

[jblack2743]

Thanks but why not borrow a 12volt line already in place.

[RichKimball]

Originally Posted by jblack2743

Thanks but why not borrow a 12volt line already in place.

That's a good one. Really can't think of why a LV xmfr would be there.
If it was me...I would write or call REV with my F.I.N and request the set of schematics for the unit. If it was factory.,..the detail should be there somewhere.

[twinboat]

Door bell or thermostat control come to mind.

[Gary RVRoamer]

Other possibilities include entertainment gear, e.g. DVD, sound system, tv, satellite dome or receiver, some kind of led decor lighting, a tv amplifier system, maybe a USB charging port, etc. Just too many things that could have been installed and are designed to get power via a "wall wart" plugged to a 120v outlet.



Definitely request the electrical and plumbing schematics from Fleetwood/Rev customer service. They can email them directly to you.

[steve52]

Unplug it and see what quits working?

[jblack2743]

Have wiring diagram no can find

[jblack2743]

I did but nothing quit working ??

[biggcrisp]

That outlet powers my outside tv. I don’t have a transformer though.

[Elwood58]

My guess is TV antenna amplifier.

[chuckftboy]

If you have an auto gen start that transformer supplies 12 volts to the EC30 circuit board. When programmed to start on loss of power, the outlet loses power and opens the 12 volts at the board to start the generator.
The only problem is that Fleetwood installs them after the transfer switch and the transformer should be installed before the transfer switch so it would see when power is restored at the pole to cycle the generator off.

[jblack2743]

When I unpluged it tv amp still worked

[jblack2743]

Thanks for imput but I do not have auto start or transfer switch