12v connection from Carefree Awning
I have a 2008 Cayman with a Carefree Patio awning. There is a master on/of switch on the entry door panel along with an extract/retract switch. Also, there is a extract/retract switch on the awning control arm outside. I'm try to pull 12v off the wires that come out the side by the awning to power a 12v led strip light. I can see where I get the 12v (yellow wire) but nowhere can I see a ground. I've attached a schematic and, not being an electrical wizbang, I'm not sure where to make ground. I may have to run a separate wire to ground???. I've not found the Carefree relay control inside yet. I see a ground on that that I could tap into??? Any help would be appreciated guys. Again, I'm not an electrician and trying to figure this thing out.
Ray & Leslie F. & the cattle dogs
2008 Monaco Cayman 35SBD
2007 Jeep Liberty