2000 Windsor - Toad plug on RV Fused?

[Downsizer]

Hi,
Trying to get my toad wiring set. I can't get any power on any of the 4 pins on the toad wire plug coming out from under rear of RV. The connector from the chassis to the toad plug ( about 12" in from toad plug) is firmly connected and no obvious wires cut, etc.
Anyone know if there is a fuse for that toad plug and more importantly where it might be?
Thanks so much!
Bernie

[Outbound]

I'm sure you did but did you turn on your lights or turn signals.

[Downsizer]

Yes, both

[jacwjames]

You might follow the wires from the harness and see if they go to another connector and/or have disconnected wires.

I had to redo my wiring and when I followed the wires there was actually another connector buried in the mass of wires under the pulley on the engine. I used this as a starting point to wire in the connector for my toad. I was able to buy a pigtail wiring harness at a local RV shop, it was not a common connector, I think it was 6 wire, rectangular.

[Downsizer]

That rectangular connector is what is in plain sight about 12" in. From it, the wires go to that massive mess of harnesses under the pulley. I'll start at that, just hard to get to and was hoping to find out if there is a fuse for that harness/toad connector?

[veraken]

Go to the Files section above and do a search on Windsor. You will find the wiring diagrams for your MH which I just uploaded. This might help you.

[Downsizer]

Wow - thanks so much!!!
Hopefully, I can find if there is a fuse and location!
Again, thanks very much!
Bernie

[Downsizer]

Update - can't find any indication of a fuse for the toad connector on the RV.... So, any further help/experience would help.
Thanks,
Bernie