On my 2008 Diplomat the purge valve leaks air all the time when the engine is running. It gets a little less after it purges. Anyone rebuilt this valve? If so please post any info you have. Here is a picture it is leaking out of the black part on the bottom.
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
And, my "Plan A" if it hasn't been serviced in the last three years would be to replace it with a factory reman (i.e. the factory that made it, NOT "made to replace....".
With a factory reman not only the filter(s) but also heater and all valves are new.
Or you could remove the valve and clean it. It may just have gunk in it.
And make sure you are changing out the dryer filter.
Tim
Tim,
I took it apart and the rubber seat is hard and has a groove worn in it. I ordered a rebuild kit and will install it when it arrives. The hardest part is compressing the two O rings to get the snap ring back in place. I used a 1 1/8 deep well socket with a extension and a floor jack to compress the O rings and get the snap ring in place.
__________________
Tim and Barbara Foster
2008 Monaco Diplomat 40 PDQ