Any tricks to pulling out the buttons that hold the dash access panel in place?
I haven't tried yet but I will be needing to pull the two padded buttons that hold the dash access cover on so that I can access the trailer brake controller wiring connector (Monaco says it should be wrapped around the headlight switch). I'm guessing these plugs are a serrated plastic pin that just pops in and out? If so, I know they are usually only good for a couple of times then they no longer fit very well. Anyone have a secret to getting these out without destroying them?
__________________
2008 Beaver Contessa 40' Pacifica 425 Cat
2011 Jeep Rubicon - Sold
2012 Ram 2500 CTD CC 4WD - Sold
|