Blackwater tank sensor location?

[Chief2K]

were do I find the sensor on the blackwater tank of a 2007 Monaco dynasty

[Outbound]

Did you look on passenger side, rear bin next to rear axle.

[Jobert]

On ours 06, the sensor is located just near the outlet from the black tank, near the valve, in the bottom of the tank. If you have the Aladdin system, it will have a telephone wire running to it. On ours, it is behind the stainless panel in the wet bay but can be reached from under the panel, closer to the middle-right side. It will be a larger plastic hex and can be screwed out and cleaned and reinstalled. You should soak it or flush gently but there is a clear membrane in there so don't insert anything in the opening to clean it. Hope this may help, Happy Trails. Bert

[vito.a]

Yes, the 2007 sensors are on the drivers side just out of site behind the panel. It screws into a pvc elbow coming out of the bottom of the tank. The wire is an RJ11 telephone style clip. I was able to barely fit a wrench in there and loosen it 1/4 turn and then remove it by hand. I wrapped the new sensor with a double layer of teflon tape and put it in by hand and then just gave it 1/4 turn to tighten.