Dash air/heat blower control module location

[garryfly]

I have a 2007 Dynasty Squire model. My dash blower stops then restarts after a few minutes. I checked the blower motor resister and all speeds work. The blower will turn off at any speed. So the next step I was told to check is the blower motor control module, Does anyone know where this is located? Some say its under the passenger dash, others say its behind the heat/ air controls. And whats the best way to get to it to replace?

[Jetskier50]

Ours is on the floor of the center console. I removed the vent cover and there it was. I changed it out and the dash A/C blower, heat etc. is still intermittent. I think I've tracked it down to the relay in the front run box. hopefully it isn't the run boards corroding due to that compartment leaking.

[hypoxia]

Do you have the schematic? Dynasty Dash HVAC is on page 170 of my wiring book. https://www.irv2.com/forums/download...do=file&id=319
The Signature has an SCS HVAC module 11-00636 (Page 9) but the Dynasty/Executive/Navigator diagram is different and I don't see a "module". My SCS module is on the center console floor same as Jetskier50.

Monaco's are snowflakes so anything's possible.

Brian, I've come to the conclusion there is no good way to keep the FRB dry and I should plan to remove & clean the backside of all of the boards in there every 5 or 6 years.

[Roadmiester]

Not sure what you mean by module. My set up is: a vacuum generator on firewall, then a vacuum line to a "module??" that is mounted to the back side of the vent selector switch mounted in center console. It is both electric and vacuum on the "module". That's how mine is.

Roadmiester
09 Dynasty

[Jetskier50]

Originally Posted by hypoxia

Brian, I've come to the conclusion there is no good way to keep the FRB dry and I should plan to remove & clean the backside of all of the boards in there every 5 or 6 years.

Thanks,

That is one thing I hae not tried to do yet. Maybe this winter.