Doorbell

[Art Tufts]

I have a 2009 Monaco Camelot DSQ. Doorbell doesn’t work. Can’t find doorbell or fuse. Please help.

[RobRoy]

Originally Posted by Art Tufts

I have a 2009 Monaco Camelot DSQ. Doorbell doesn’t work. Can’t find doorbell or fuse. Please help.

I don't have that make or model, that said on mine and many other models the door chime is in the rear salon in the cabinet under the sink and the fuse is in the fuse panel in the rear walk-in closet.

FYI I have my owners manual in PDF form and makes for grabing this information very quick and is located on my pc and also my laptop for easy access.... I think staples changed me a few bucks do so

Happy Hunting

[devildawg]

I had a 2005 Dynasty and the doorbell stopped working. It turned out to be the wiring on the push button. I took the button off and re-connected the wires. Easy fix.

[Mhcorrigan]

My chime is in a cabinet above the table and is powered by batteries. No fuse and only wiring is between button to activate chime and chime. Check your outside button and you can touch the two wires together and if the chime works your button is bad,

[Captjake1]

Ours is in the passengers side console right at the door (2008)

[RustyTools]

Not sure which of your same posts I should respond to, but will try here.

Is it a TriMark? Do you have the lighted grab-handle? If so, does the light work, or any of the pushbuttons for the locking portion? We can start and go from there.

None of my functions worked, and it turned out to be the control module. Doorbell was hidden in the wall-mounted console to the right of the passenger seat.


EDIT: you type quicker than me, John

[96 Wideglide]

Originally Posted by Captjake1

Ours is in the passengers side console right at the door (2008)

+2.

[vito.a]

Like RobRoy said, download your owners manual here:
https://www.monacocoach.com/rv-owners-manuals

Our door bell chime is in the bathroom cabinet under the sink area. I purchased a standard door bell button from Home Depot and ours now works well.

[tankcj]

There is a known problem where the doorbell amperage draw was too high for the keypad and over time would burn out the keypad. If this is your case (it was for me) contact Trimark. They have a fix for it.

In my case, the entire keypad failed and needed to be replaced along with adding in a relay.

[hypoxia]

http://www.trimarkcorp.com/en/media/...20RVs_Rev1.pdf

[Art Tufts]

It has the lighted grab bar. The light works as do all the other buttons and the door lock.

[Outbound]

Ditto on outside button being your problem.