Emergency Flasher Wiring for Trailer
Thanks to information on this forum I was able to find the wiring information to put a brake control in my 2005 Knight, thanks. I also found that either the factory or the original owner had the lights wired to the trailer plug without a converter (4 to 2 light ) so the trailer only had signals but no brake lights, that is now corrected.
So here is my last problem, when I turn on the emergency flashers, it does not flash the lights on the trailer. The emergency flashers appear to be on a totally separate circuit. I have found a power wire for the flashers in the wire harness that the chassis sends to the back and terminates. However if I attach the flasher wire to the brake line after the convertor the flasher quits flashing. If I attach to both individual signal wires before the convertor this will cause a cross connection and both lights will signal when you are trying to get only a turn signal.
I am uncertain where to go from here, I have the power I need, just not sure where to connect it. Anyone else experienced this?
Any ideas appreciated