On page 141 of the wiring diagrams it shows the cooktop being primary over the washing machine, as I read it. You have two Intellitec boxes, one may be bad.
__________________
2014 Newell 2020P 45'8" ISX 600 HP
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
On page 141 of the wiring diagrams it shows the cooktop being primary over the washing machine, as I read it. You have two Intellitec boxes, one may be bad.
Thanks. Been busy with other annoyances lately. My AGS went nuts yesterday and kept starting on its own (my fault). Trying to get that and inverter setup figured out.... Almost done there.
Anyway, I'm pretty sure I have all the relative docs and schematics, just not the time to dive into them quite yet. It's appears there may have been a hiccup at the factory as to the wiring.
As stated earlier, this coach has some/all 120v options. Unless the two breaker boxes are generically labeled and just don't list them, however I have higher rated breakers than the labeles show in some cases.
You mentioned 2 Intellitec boxes, are you referring to the "breaker" boxes in the coach or something else? I have one in the rear with the BB in it.
Which brings me to something I've been meaning to ask... Where is the actual shedding controlled from? I am assuming a remote control module which actuates relays and or solenoids to apply or take away power as needed.?
Gotta go, my wine glass is empty [emoji12]
__________________
John & Clare Lyon
2007 43.5' Monaco Dynasty Palace III (All Electric)
Towd: 2011 Chevy Equinox
My 08 Endeavor does indeed load shed. I can also manually turn the charger down or even off. It does NOT load shed when on 50 amps.
I suspect your 07 should be very close to this manual and video.
Well after doing some research and testing today I discovered I needed to let the inverter know my banks total AH rating, type of batts, LBCO, Search watts, ect. I also discovered shore was probably set to something less than 50a, just not sure, just understand now it would make a difference.
Really appreciate the help from all of you here!
__________________
John & Clare Lyon
2007 43.5' Monaco Dynasty Palace III (All Electric)
Towd: 2011 Chevy Equinox
Ahhh John...................... Thats what AGS does
Dang Ben, you're simplely just amazing because of your superior knowledge of RV systems. Who would have thought the AGS system setup had to do with parameters for Automatic Generator Starting! You are a hero in the RV community! Not go to bed, it's late.
__________________
John & Clare Lyon
2007 43.5' Monaco Dynasty Palace III (All Electric)
Towd: 2011 Chevy Equinox
You mentioned 2 Intellitec boxes, are you referring to the "breaker" boxes in the coach or something else? I have one in the rear with the BB in it.
Which brings me to something I've been meaning to ask... Where is the actual shedding controlled from? I am assuming a remote control module which actuates relays and or solenoids to apply or take away power as needed.?
http://www.intellitec.com/assets/pdf...-00714-000.pdf
Two of these are wired together. As I read it, the first one gives the stove priority over the washer and 3rd A/C and the washer is given priority over the 3rd A/C.
The note states:"When only one of the options (electric stove, center A/C, washer/dryer) is called for the 12/2 w/gnd wire from the main panel connects directly to the optional recept, thereby bypassing the relays altogether.
Stovetop option in all-electric models only"
Also, there is a note for the Intellitec module location "next to washer/dryer recept, next to main breaker box, behind TV, or under bedroom wardrobe"
Mine was bad and was under my bedroom wardrobe.
My front TV is a drop down, doubt it's there. The 2 120v breaker boxes up front above driver's seat is in a very small area and I know they wouldn't be next to them. Nothing around bedroom TV. A panel on the side of the stackables reveals the washer receptical, not apparent they are there unless I pull the washer. I suspect then they are under the wardrobe. However, nothing in there except the floor safe. Unless they are outside under the closet. There is a cabinet full of wiring and electronics in there but those 2 modules aren't in there.
I'll keep checking and re-checking until I find them. Thanks all!
__________________
John & Clare Lyon
2007 43.5' Monaco Dynasty Palace III (All Electric)
Towd: 2011 Chevy Equinox
I finally found the elusive Intellitec AESS moduals. They were in the wardrobe, however I had to remove the entire floor safe and they were under that. The only reason I figured this out is I found the 38031173 schematic (thanks Jim!). The PO had crossed out the 4 places Monaco said they could be found. And wrote Floor Safe.
Yeah technically they were under the wardrobe floor 😠.
So Impatient me had to jump right in. I just switched the stove Romex to the washer position and vise versa. Yep stove trump's rear AC now. The OOPs is there is no power at all to the washer now. More drama to come 😊
__________________
John & Clare Lyon
2007 43.5' Monaco Dynasty Palace III (All Electric)
Towd: 2011 Chevy Equinox
Yeah, them suckers must be priceless! Either that or they (Monaco) have a lousy sence of humor. You can't eat until the laundry is done and the bedroom is cool.
__________________
John & Clare Lyon
2007 43.5' Monaco Dynasty Palace III (All Electric)
Towd: 2011 Chevy Equinox