Community Forums

Rolly Zimmer · 04-30-2013, 12:36 PM

I just found that my intake hose at the intake end was rotten, I managed to cut off the worst area and reattached and clamped and working ok. Question is I have to order new so I can avoid any problems in the future, this hose has likely been on since 2006 . I have been doing a lot of internet surfing but can not find a place to buy hose in Canada or the US at this point. Anyone had to deal with in the past. Thanks

Rolly

Steve Ownby · 04-30-2013, 12:58 PM

You should be able to find something here:

http://intakehoses.com/

dennis45 · 04-30-2013, 01:01 PM

If you have a NAPA, Acklands Granger or similar industrial supply store, take the old one or a photo with measurements to match up a new one. They are very common on trucks so try a Cummins, Detroit, or Cat store.

Good Luck

mark8061 · 04-30-2013, 01:16 PM

I had to replace an air bag on my mh. Ordered from Airassisted.ca they have everything you will need.

dennis45 · 04-30-2013, 01:31 PM

Quote:

Originally Posted by mark8061

I had to replace an air bag on my mh. Ordered from Airassisted.ca they have everything you will need.

All due respect, the OP is looking for connector parts for the air intake system to the engine. A good site for air ride suspension though.

This one might be a little more to the point. There are local suppliers for this stuff as mentioned.

http://www.donaldson.com/en/engine/s...ary/055474.pdf

97windsor · 04-30-2013, 01:33 PM

After much searching on the net I found a company that makes all sizes of flex hose from 1" to 24" flex. It is Blastgate.com. Go to the site then click on flex hose and pick from about 15 different styles. The one on my MH was the PVC coated fabric with wire. I used the T7 version from the site. It has a smooth interior and working temp of -40 to 275F . It has been on my MH for approx. 2yrs.
This is the flex hose BEFORE the air filter that goes to the top of the coach for engine air intake.