|
|
05-08-2021, 07:46 PM
|
#1
|
Senior Member
Join Date: Oct 2006
Location: Pensacola FL
Posts: 122
|
HELP wife upset DUE TO TRAVEL TOMORROW
2005 Monaco Windsor Pulled unit out of shelter today, washed, and was doing ok. Wife started driver side bedroom slide out and it stopped after 6 inches travel. Looked for any binds and found none. There are no clicks or noise heard. Can not find any information. Where are the fuses and control boxes. It will not go out or in. No noises from relays as a hint where located. Help me get out of trouble. Thanks for any reply.
|
|
|
|
Join the #1 RV Forum Today - It's Totally Free!
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
|
05-08-2021, 07:52 PM
|
#2
|
Senior Member
Join Date: Oct 2006
Location: Pensacola FL
Posts: 122
|
Forgo to say 40 PDQ. Thanks.
|
|
|
05-08-2021, 07:54 PM
|
#3
|
Member
Join Date: Sep 2014
Location: Maggie Valley, N.C
Posts: 92
|
I have a 2006 Camelot 40pdq and the slides have resettable fuses in the passenger side rear electrical bay. I had one slide that would pop the fuse and I would reset it often, when at national indoor Rv for awning work he replaced it with a auto resetting one and I haven’t had a issue in five years.
Hope it helps!
|
|
|
05-08-2021, 07:59 PM
|
#4
|
Senior Member
Monaco Owners Club
Join Date: Jun 2014
Posts: 14,603
|
You might try turning the salesman switch off and on. When my slide stops working I do this and it will start up.
__________________
Jim J
2002 Monaco Windsor 38 PKD Cummins ISC 350 8.3L
2005 Jeep Grand Cherokee w/5.7 Hemi
|
|
|
05-08-2021, 08:15 PM
|
#5
|
Senior Member
Join Date: Oct 2006
Location: Pensacola FL
Posts: 122
|
Thanks for both reply's. Salesman switch wired around years ago. I will look in electrical rear bay at this time. Someplace to start. Thanks
|
|
|
05-08-2021, 08:17 PM
|
#6
|
Senior Member
Join Date: Oct 2006
Location: Pensacola FL
Posts: 122
|
Thanks jandridge. I have a place to start. Thanks jackwjames Salesman switch wired around years ago. Thanks for each reply.
|
|
|
05-08-2021, 08:43 PM
|
#7
|
Senior Member
Monaco Owners Club
Join Date: Jun 2011
Location: CA
Posts: 4,486
|
Do your basement doors have safety/lockout switches?
__________________
Bill & Brigitte
06 Windsor PEQ, Cummins 400 ISL
2014 Honda CRV or 2012 Jeep
|
|
|
05-08-2021, 09:07 PM
|
#8
|
Senior Member
Join Date: Oct 2006
Location: Pensacola FL
Posts: 122
|
Found a quad slide control relay in rear electronic compartment. Found both driver side slides do not work but quad slide control clicks when any slide switch is pressed. Both passenger side slides work and both driver side slides do not work but quad slide control relays click any time switch is pressed. This started after a wash job. Could it be something got wet?
|
|
|
05-08-2021, 09:10 PM
|
#9
|
Senior Member
Join Date: Oct 2006
Location: Pensacola FL
Posts: 122
|
My basement doors has the auto lock from the front door controller. Thanks
|
|
|
05-08-2021, 09:21 PM
|
#10
|
Senior Member
Excel Owners Club Winnebago Owners Club Ford Super Duty Owner
Join Date: Aug 2014
Location: Santa Fe, NM
Posts: 6,814
|
Quote:
Originally Posted by Jim McElwee
Found a quad slide control relay in rear electronic compartment. Found both driver side slides do not work but quad slide control clicks when any slide switch is pressed. Both passenger side slides work and both driver side slides do not work but quad slide control relays click any time switch is pressed. This started after a wash job. Could it be something got wet?
|
In trouble shooting last thing done prior to a failure is always a suspect. Water in relays can do strange things. Can you pull those relays and get them dry or dry them in place? Another possible source is in the ground wire between the relay and its grounding point. If wet, it may not be making a good connection. Bad grounds are common sources of problems. You can test this by simply adding a temporary ground between the relay and a know ground point. This is called adding a ground. The fix maybe just replacing a bad ground with new wire.
__________________
Fred & Denise (RVM157) New Mexico
2007 Excel Classic 30RSO & Coach House 272XL E450
2007 RAM 3500, Diesel, 6Spd Auto, SWD, 4x4, CC & LB
[SIGPIC][/SIGPIC]
|
|
|
05-09-2021, 01:51 AM
|
#11
|
Senior Member
Join Date: Dec 2018
Posts: 323
|
Is your battery fully charged?
|
|
|
05-09-2021, 09:09 AM
|
#12
|
Senior Member
Join Date: Jul 2019
Posts: 121
|
Quote:
Originally Posted by Scott 3
Is your battery fully charged?
|
X2 agreed
|
|
|
05-09-2021, 10:46 AM
|
#13
|
Senior Member
Join Date: May 2004
Posts: 208
|
Grab your wife’s hair dryer and do some blowing, enlarge those 2 small drain holes at the bottom, don’t ask me how I know, ended up having to buy a new board to learn
|
|
|
05-09-2021, 11:36 AM
|
#14
|
Senior Member
Monaco Owners Club
Join Date: Jun 2014
Posts: 14,603
|
Is the fuse good in the control module. On mine the rear slide would work but the front wouldn't until I replaced the fuse.
__________________
Jim J
2002 Monaco Windsor 38 PKD Cummins ISC 350 8.3L
2005 Jeep Grand Cherokee w/5.7 Hemi
|
|
|
|
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Discussions |
|
|
|
|
|
|
|
|
|
|
|
|
|