Community Forums

Geneandea · 06-25-2013, 07:42 AM

I have a 1999 HR DP having problems with one front jack coming up. I have ordered new springs, will install when they come in. My question is proper sequence on raising jacks. I usually raise both front and back store levers, and usually forget to start the engine first

. I know I should start engine first and then raise the front jacks first. I know this sounds dumb, so why engine start (air bags inflation?) front lever first then the rear? I called HWH but they are back logged on tech support

When putting jacks down I put both levers down then begin moving jack control lever, should I only do one? the manual talks about pairs front and back or do both front and back for a side when using the control lever?

Thanks

cc8375 · 06-25-2013, 02:39 PM

Was instructed years ago, front down first then rear. When stowing, Rear first then front.

Hopefully a spring, Had the same problem , years back, was a bent jack, used a 3' pry bar and board to stow. Alway put the jack down on a board.

Good luck!