Hydraulic filter

[windsorman]

I have a 1999 windsor with the cummins 330 and need to know the number of the remote in line filter for the hydraulic fans and power steering,this filter is separate from the large cannister filter.

Thanks

[lonestarace]

These were what I was able to use on our 99 Monaco Executive w/450 Cummins

NAPA#1759=Wix#51759=Fram#PH3567, Fleetguard#HF6710

[Windecker]

You should be able to clean the filter with a towel and some fuel, solvent, degreaser, oil... Google what ever number you find and I am sure you will get your answer.
If the numbers are worn off and totally unreadable I would then check with Monaco, if that does not work you may need to measure the filter gasket diameter, thread diamter, thread pitch and do a little research on what Micron filter is used for hydraulics.
Also the filter head may have a number cast into it which may be of some use figuring out what filters mate to it.
Hope that helps.
Windecker

Originally Posted by windsorman

I have a 1999 windsor with the cummins 330 and need to know the number of the remote in line filter for the hydraulic fans and power steering,this filter is separate from the large cannister filter.

Thanks

[windsorman]

Originally Posted by Windecker

You should be able to clean the filter with a towel and some fuel, solvent, degreaser, oil... Google what ever number you find and I am sure you will get your answer.
If the numbers are worn off and totally unreadable I would then check with Monaco, if that does not work you may need to measure the filter gasket diameter, thread diamter, thread pitch and do a little research on what Micron filter is used for hydraulics.
Also the filter head may have a number cast into it which may be of some use figuring out what filters mate to it.
Hope that helps.
Windecker

Thank you< I will give this a try

[windsorman]

I appreciate the help,Thanks

[walt2137]

Originally Posted by windsorman

I have a 1999 windsor with the cummins 330 and need to know the number of the remote in line filter for the hydraulic fans and power steering,this filter is separate from the large cannister filter.

Thanks

If this is for the Windsor with a ISC 330 engine The filters you will need is 3 Nelson 84101B sock filters and should cross to a Donaldson P550698, remove the wing nut & washer(dont drop it) using a coat hanger fish out the 3 filters and let drain, you will be about 2 or 3 quts low on fluid and if the fluid has a red tint it will be Dexron lll, if it is yellow or clear it will be AW46, in some Monaco coaches they also put 10W40 engine oil.
If it is for the Exec with the ISM it uses one filter.

[Mike Canter]

My filter is at a low spot and when I took it off I dumped 13 quarts of ATF. It needed changing. According to Monaco if you use your MH in cold weather then use ATF because AW46 is too thick and pressure will be too high and might damage the cooler