Looking For Slide Out Seal

[loydt]

I need to replace a section of mine. It is torn at the bottom and I think it
might be where the water is getting in at the bottom of my bed slide. It is the seal that goes on the slide behind the wood fascia, close to the edge. It
appears that it sticks on with its on adhesive?

Anybody else have to replace this? Where to buy?

[ArmyEOD]

Loyd, if you can not get them from Monaco, try Parkins Accessory 1-800-737-8938, they may have a web site, not sure.

George

[ArmyEOD]

OK, her is the web site www.parkin-acc.com
George

[Steve N Sal]

Can you explain torn or is it more of a slice down the middle. If it's the later of I bought some glue that can be used in this situation from Home Depot. It was in the paint department. Ours had about a 10" slice down the middle. I applied the adhesive and reformed the seal. Held with my hands until I could let go and then just let it dry. The next day I went over the same spot but applied it a little heavier and smoothed it out to a wider area about and inch or so on either side of the slice and then let that set up. It stays real pliable and has been good to go now for three years with plenty of opening and closing of the slide. Our repair was at the top portion of the living room slideout just where it wraps down from the roof of the slide. Just a thought. Hope you find a solution for yours.