Originally Posted by Skinden
This problem is on a 01 Endeavor. Is this something that I can replace without a lot of problems?
melted from what? If it's resting on something hot, you can replace it with new plastic tubing and route it away from the heat.
If it's original, I'd pull out the fridge and replace all of it. It gets brittle over the years from age and could start leaking. If you just want to replace the part you can access from the outside panel, you can cut it above where it is melted, get a coupling and replace the damaged portion. That tubing and fittings are available at Home Depot, lowes or most hardware stores.
My tubing is wrapped in foil tape and inside that are wires to keep the tubing from freezing. You can unwrap the wiring and then re-install the wire/foil tape when completed.