The top of the lift in the photo is on the right side and the lower end is on the left. The loop is for manually moving the lift.
Motor is 120 VAC
Manual Movement – Facing Forward it is on the Left side of TV
Push IN to Engage Gears – Pull OUT to Disengage Gears
Turn CW to Lower TV
Turn CCW to Raise TV
Lift It 120 Volt Controller
Infrared JP6 Not Used
Interlock JP4 Source and Return are Jumpered Together
Wired Remote JP5 Ref. Not Used although Monaco Had a Ground wire attached
JP5 “Open” – Yellow wire is 12VDC when Open switch is Pressed
JP5 “Close” – White wire is 12VDC when Close switch is pressed
Motor Connector JP3 Located inside controller. Wire plugged into JP3 goes to the Motor.
JP3 Earth is Ground
JP3 Up applies 120 VAC to Motor when Up switch is pressed activating JP5 “Close”
JP3 Down applies 120 VAC to Motor When Down switch is pressed activating JP5 “Open”
JP3 Power is Neutral wire to Motor
Pressing “UP” switch sends 12 VDC from Multiplex Module (rear closet) to the Lift It Controller (above Windshield) JP5 “Close” white wire and activates a relay which applies 120 VAC to JP3 Up pin
Pressing “Down” switch sends 12 VDC from Multiplex Module (Rear Closet) to the Lift It Controller (Above Windshield) JP5 “Open” Yellow wire and activates a relay which applies 120 VAC to JP3 “Down” pin
Troubleshooting
TV will not raise – I have unplugged motor wire at controller JP3 and unplugged 120 VAC source, the relay clicks and everything starts working like normal (same symptom & cure 2X)
[IMG]Motor is 120 VAC
Manual Movement – Facing Forward it is on the Left side of TV
Push IN to Engage Gears – Pull OUT to Disengage Gears
Turn CW to Lower TV
Turn CCW to Raise TV
Lift It 120 Volt Controller
Infrared JP6 Not Used
Interlock JP4 Source and Return are Jumpered Together
Wired Remote JP5 Ref. Not Used although Monaco Had a Ground wire attached
JP5 “Open” – Yellow wire is 12VDC when Open switch is Pressed
JP5 “Close” – White wire is 12VDC when Close switch is pressed
Motor Connector JP3 Located inside controller. Wire plugged into JP3 goes to the Motor.
JP3 Earth is Ground
JP3 Up applies 120 VAC to Motor when Up switch is pressed activating JP5 “Close”
JP3 Down applies 120 VAC to Motor When Down switch is pressed activating JP5 “Open”
JP3 Power is Neutral wire to Motor
Pressing “UP” switch sends 12 VDC from Multiplex Module (rear closet) to the Lift It Controller (above Windshield) JP5 “Close” white wire and activates a relay which applies 120 VAC to JP3 Up pin
Pressing “Down” switch sends 12 VDC from Multiplex Module (Rear Closet) to the Lift It Controller (Above Windshield) JP5 “Open” Yellow wire and activates a relay which applies 120 VAC to JP3 “Down” pin
Troubleshooting
TV will not raise – I have unplugged motor wire at controller JP3 and unplugged 120 VAC source, the relay clicks and everything starts working like normal (same symptom & cure 2X)
The controller should be behind a false cover in a cabinet above the windshield.
Linear Mode
