Community Forums

Dusty111 · 08-03-2021, 05:53 PM

OK This weeks problem....
05 Monaco Windsor....My 4 Door Norcold fridge does not work unless the Generator is on....when not on fridge says no ac or no flame in LP mode probably because the fan is not moving the wand to turn on the Gas....I've checked circuit bkrs and fuses that the Manual show related to fridge...

Help....any clues would help save some food

YC1 · 08-03-2021, 06:24 PM

It takes 12 volts to run a refer (not always), the circuit board controls things.

IF it is not working without the generator, do you mean you are plugged into shoreline?
Grab a meter or something to test the outlet at the back of the refrigerator. While back there change meter to DC range and see if you can find 12.5 volts anywhere.

There is not likely any fans needed for the refer to light as does a floor heater.

vyndance · 08-03-2021, 06:25 PM

Are you plugged in?

shootist · 08-03-2021, 07:06 PM

You have 2 different 120v circuits behind the fridge, one is inverter, for the icemaker, and one is not. Swap them and see what happens. Also your dc fuse should be in the rear run panel. It will throw ac codes before dc , pinch the fuse terminals with pliers to tighten them a bit , then push the fuse in and out a couple of times.

Dusty111 · 08-04-2021, 09:26 AM

Thanks the FREEZER Fuse was dirty pulled and inserted Twice....solved the problem....THANK YOU FOR THE HELP !!!!

Quote:

Originally Posted by shootist

You have 2 different 120v circuits behind the fridge, one is inverter, for the icemaker, and one is not. Swap them and see what happens. Also your dc fuse should be in the rear run panel. It will throw ac codes before dc , pinch the fuse terminals with pliers to tighten them a bit , then push the fuse in and out a couple of times.