Prevent a freeze

[JFC]

We have a 2007 HR Scepter. From mew, it's never been in an area that needed winterization, so we've never used the Swan Industries prevent a freeze that was installed at the factory. I recently notices a hose in the engine compartment that had deteriorated and broken. Inspecting it, at first I couldn't locate the beginning or end of it. It is the same type of hose coming from the add antifreeze tank of the prevent a freeze. The Swan website indicates that the system has a tank and several solenoids in addition to the control panel. E-mailing Swan for information, they only gave instructions on removing the system, no indication where the components might be found. Since we've never used the system and one hose has already failed, I'd like to completely remove the system before another failure causes a problem. Anyone have an indication of where Monaco may have located these components? I was surprised that there was a section of hose in the engine compartment.

[Ray,IN]

Mine(different MH brand) is installed in the same compartment as the water heater and water pump since that is where adding RV antifreeze begins. Look at your water heater plumbing and the bypass piping, this should offer a clue. The RV anti-freeze holding tank will be where it's easy to access. My tank is opaque 2 G square plastic with a 1.5" plastic pipe plug in the top.