Community Forums

mb2875 · 08-21-2018, 02:01 PM

My levelers sank into some some soft ground and when I pulled out the drain valve snapped off after hitting the ground and a piece of it stayed in the fitting that attaches the assembly to the chassis. The fitting has a threaded outside to bolt into the bracket and the inside threads allow the airline to thread inside. the other end is threaded inside to accomodate the drain valve. Does anyone have a part number or parts list for this system?

CountryB · 08-21-2018, 02:17 PM

Take a look at these drain valves. You should be able to match something to what you have.
https://www.anythingtruck.com/catego...ves-drain.html

RamiDav · 08-21-2018, 02:35 PM

Mike ,
I doubt the part you are describing will be on a parts list , I imagine
that Monaco had a parts bin of misc parts at each station .

A good hard ware store or truck parts store may have what you need .

Before trying to track it down have you tried removing the piece ?
An easy out will probably unscrew it for you .

I have even drilled the piece so that the wall of the piece is thin

leaving the threads intact .

Then picked it out with a punch or even a sharp nail or knife .

Ray

mb2875 · 08-21-2018, 03:17 PM

Thanks for the replies. I did try an easy out but it was so tight it just cleaned out the inside and left the threaded portion intact. I can only guess that the corrosion and the side force from breaking off really jammed it in there really good. It probably is a unique part for monaco...I'll just keep looking. I had this happen about three years ago and I want to remember monaco gave me a part number which I found on the internet. Have'nt been about to find it.