Community Forums

Bay237 · 08-02-2013, 12:04 AM

Have 2001 Dynasty Fresh water valve not working. Will not accept water from outside supply. Does anyone have diagram on changing valve. Ordered one from monaco, but they do not have a diagram. Looks like I will have to cut through the wall.

Also looking for motor for 2000 Girard awning. any help would be greatly appreciated. Girard wants $800 for new motor. though of taking to shop to see if it can be repaired.

Thanks

danes-on-tour · 08-02-2013, 12:36 AM

Just a thought - I can get the same effect (no water) if I pull out my hose 100%. This creates a kink on the hose where it is connected in the wet bay, and this in turn cuts of water supply to the MH.

I can get to my valve via a hatch in the wet bay - it is located right above the valve. Do you really need to cut a hole to get to it?

Bay237 · 08-03-2013, 11:50 AM

Can't get to the valve. Panel is solid only valve handle rod sticks through solid panel.

Thanks for your reply

DtBt · 08-03-2013, 12:57 PM

My experience on my Windsor is the valve can leak but the ball valve is pretty reliable. You may have an obstruction or the handle is slipping on the ball. When my valve leaked I replaced it by loosing the panel and cutting out a section of the pex piping, replacing the valve then crimping section back. You must cut section where you can get a crimper in to recrimp. I did not have room to use the "shark" crimpless valve.