On my Windsor the sw is in the top left of the pass slide , in the overhead
cabinet behind the pass chair .
That sw is mounted on what I call a bumped out part of the wall .
Behind that little bump out is the controller box , actually 2 little elect boxes .
One is the actual control box the other is a current limiter device that is sort
of a backup to the stop switches .
Be careful in there , the awning uses 120 volts
After studying it bit perhaps you can see where the power comes in and where
it goes out to the motor .
Assuming power is present you can jumper to see if the motor operates .
The current limiter is a known troublesome part , I read somewhere that they
no longer use it and I have also read that you can eliminate it by just unplugging
it and reconnecting without it in the circuit .
I haven't done that on mine but I plan to try it since mine will stop at times .
I didn't ask if you are plugged into elect power
I don't believe the awning will operate on the inverter , although I'm not
positive about that .
Good luck
|