I have a 2003 Monaco Dynasty with a flat floor living room slide. I am having an issue with the adjustment on that slide. It rubs on the carpet when the slide is traveling in or out and once out the top of the slide does not seal to the coach. It is about 1" from the interior wall which allows cold air to enter the coach. The slide unit is the HWH Hydraulic type. I have tried adjusting the bolts on the outter edges of the slide posts but all this does lower or raise the outside of the slide. It seems as though the adjustment will need to come in the guide bar that the slide out floor slides on however I cannot find any way to adjust that. Any help would be greatly appreciated.
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
Check to make sure slide topper isn’t binding keeping the top of the slide from full travel.
I just replaced the slide topper because it was damaged and I thought it was holding the slide top from going out all the way. It is not holding it up at all