Slideout adjustment procedure?
My curbside slideout includes the J-lounge and kitchen counter, sink and microwave, so it's pretty heavy. The slide pinches and is cutting the rear seal at the top, where the slide lock mechanism passes. I'm pretty certain it is a PowerGear mechanism. Does anyone have or know where I can go to find a step-by-step alignment/adjustment procedure? I have tried adjusting the rollers with no improvement. Searched postings hereand found some ideas, but would prefer to do it by the book, if I can get the book!
The PowerGear documentation says the bottom slide rails should be the same distance below the slide floor. Mine is lower at the rear, and looks very slightly bowed, as if there is a lot more weight at that end. Admittedly when the cabinets are full there is going to be more weight, but could it be enough to cause noticeable flex with the slide all the way extended?
Any help will be appreciated.
__________________
Roger, Jenny and Sasha
2004 Monaco Windsor pst
2010 Nissan Frontier crew
|