Water filter location on 2006 Monaco Camelot?

[747guy]

Trying to winterize. Manual says to remove elements from filters and replace the bases before blowing out.
My 2001 Dynasty has access to a space at the rear of the last pass thru bay where the warblock system, water pump, heater bypass and water filters located.
All I can find is a drinking water filter in the galley.
Water pump is in the fresh water reel access panel roadside bay. Aqua Hot is accessed from curb side bay.
Water filters???????

[RustyTools]

With our new-to-us '08 Camelot PDQ, I finally found my water filter canister (no filter in it) waaaay back in the wet-bay. It was connected but just laying there and actually closer to the propane tank curbside.
Only way to access it was to go into the curbside bay in front of the propane bay and then reach it from the fore-aft pass-thru between them. By the accumulated dirt/bugs/etc, I doubt it had been moved in years.
I lengthened the hoses and mounted it on the wet-bay wall, where I can change the filter when needed.


Hope this helps.

[747guy]

I looked through brochures from Monaco and discovered I have a 2008 42 SDQ bath and a half.
It was sold to me as a 2006.
It has a tag axle and the first floor plan I have found is the 42SDQ 42 feet 10 inches.
Anyone have an explanation?

[Dennis4809]

Originally Posted by 747guy

I looked through brochures from Monaco and discovered I have a 2008 42 SDQ bath and a half.
It was sold to me as a 2006.
It has a tag axle and the first floor plan I have found is the 42SDQ 42 feet 10 inches.
Anyone have an explanation?

I had a similar issue. Bought a 2006 MH but when registering in WI, DMV used the chassis serial number and registered it as a 2005. I contacted the mfg and they confirmed that it is in fact a 2006. Also sent a letter that in the RV industry, the mfg established the year. Can be up to 2 yrs difference between the chassis date and the MH date.

Dennis