Community Forums

luckyd · 07-14-2014, 02:16 PM

2002 Windsor
The water pressure is very good when hooked to c/g water.
I put in a new water pump.
The pressure on the discharge side of pump is very good
The pressure in the sinks, toilet, shower is poor using the pump.

Question........anyone know where the connection of city water
and pump would be that might interfere with the flow?
I have a manabloc with all the hot and cold in one compartment.

There must be some kind of block after the pump if the pressure is
OK using c/g water.

Suggestions

trackman · 07-14-2014, 02:35 PM

If you have a filter blockage the city water could be pushing the pressure up and the pump not able to push through. Just a thought

BFlinn181 · 07-14-2014, 03:35 PM

I guess you don't have to physically switch a valve to change from tank fill to city water? As trackman suggested, a filter can drop pressure. You might also remove and clean aerators at each faucet.

luckyd · 07-14-2014, 04:23 PM

The faucets, etc have all been cleaned.
As I said......great pressure when using city water.
Low pressure when using the pump.

I never use both together.
There is no filters.
The pump is new.
Good pressure on discharge side of pump.

K7JV · 07-14-2014, 05:33 PM

You might give Monaco Tech a call. We did that on our last coach, and asked them if they had a plumbing diagram. They did, and emailed it to me. It was in AutoCad format, but I was able to open it with AutoSketch, which I already had. Also, there are AutoCad viewers that I think are free that would let you view it, if they have it. It's worth a try.