I have a 2002 Windsor and the ABS and ATC light stay on most of the time. Is there something related with these two being on mostly together? thanks Britt
iRV2.com RV Community - Are you about to start a new improvement on your RV or need some help with some maintenance? Do you need advice on what products to buy? Or maybe you can give others some advice? No matter where you fit in you'll find that iRV2 is a great community to join. Best of all it's totally FREE!
You are currently viewing our boards as a guest so you have limited access to our community. Please take the time to register and you will gain a lot of great new features including; the ability to participate in discussions, network with other RV owners, see fewer ads, upload photographs, create an RV blog, send private messages and so much, much more!
I have a 2002 Windsor and the ABS and ATC light stay on most of the time. Is there something related with these two being on mostly together? thanks Britt
They are both the same system. You may have a wheel sensor that is bad or out of position.
__________________
Steve Ownby
Full time since 2007
2003 Monaco Signature
My abs light comes on often. In my front bay under the driver seat I have a small board ( maybe 3 in x 3 inch) it has a red led and a reset switch. The led light turns on as well as the abs light on your dash if there is a fault in the abs system.
If you press and hold the reset switch for 3 seconds the led should flash twice then pause and then twice again. That means zero error codes. Then the led light should remain off. It may take a couple of times to reset the board.
I usually have to reset mine before I move the rig. The shop can't find anything wrong. So I just live with it.
Linear Mode
