Slide lock or ignition should affect everything.. I do not hear the solenoid click on my Intruder either... (2005)
Suggestion: Take a look under the slide.. If there are two long toothed rails there we are good.. Now look between the bottom of the slide and the basement compartment, under the slide, you should see a square shaft, running from one rail to a gear box to the other rail. There may be a 3/4" nut on the "Outside" of the rail (Inside is where the square saft is) on one end.... Or not.. (Do not worry about this now)
While watching the rail have someone push the botton for one second.
Does rail turn.
Does motor (Attached to gear box in middle) seem to run.
IF motor runs (or rails turn) you have sheared pins, these pins are 1/4" Grade 8 Bolts (normally) you want them long enough that the SMOOTH shank of the bolt goes all the way through the square shft.. Add washers (Flat not lock, and thick if you get 'em to build up the square shaft a bit so you can properly tighten down a NYLOCK nut.
I used to buy this stuff by the dozens in the old days, Still do but not as often since I started buying bolts long enough.
IF the motor is not running,,,,, You have a problem
If you need more help post, I have replaced a whole bunch of shear pins.
__________________
Home is where I park it!
|